Cover for Conductor, Pin and Disk Insulator

Protective Cover for Conductor
Offers the largest area of protection for energized parts and is therefore the most used in live line work.
Available in various models to suit different types of electrical installations with nominal voltages up to 48.3 kV.
Their ends have male/female fittings, which allow two or more units to be firmly connected or connections to other models, such as pin insulator covers and
disk insulator covers.
Specifically, the RP406-0184 / RC406-0181GA / RC406-0514GA even allow connections to rubber conductor covers.

The metal clips with eyebolts are used to install the roofs on the network using the remote method.

In the specific case of the RP406-0184 and COB03335-2 covers, this is an option for those users who wish to install using the contact method.

The universal head fixed to the end of the pole makes it possible to pre-adjust the installation angle of the cover.

Protective Cover for Pin Insulator
Designed to protect the energized conductor next to the pin or pillar insulator, they are normally used in conjunction with conductor covers, to which they can be attached using standard fittings.

Its adjustment on one side allows it to be better adapted to various crosshead widths.

Several models are available, which vary according to the application and operating voltage.

Some have metal clips for remote installation, others have no clips for contact installation.

Protective Cover for Disc Insulator
Protects energized parts next to disc insulators in anchor chains.

They have fittings at the ends, one side for coupling to the insulator and the other for coupling to the conductor cover. Some are equipped with a metal clip for remote installation and an elastic tie to better secure the edges.

Applicable to both conventional and polymeric insulators.